大侠客
发表于 2019-1-21 14:21:22
谢谢分享，楼主辛苦了
xiaodaishu
发表于 2019-1-22 21:57:30
本帖最后由 xiaodaishu 于 2019-2-11 17:50 编辑
请用新版本V2.5，更新crc
http://www.diybcq.com/static/image/filetype/zip.gif TL866.zip (1.06 MB, 下载次数: 0)
1. Browse for update.dat file (any version is good including the new 6.80, 6.81 and 6.82)
2.Select the firmware dumper and click reflash.
3.After reflash click the advanced button
4.Now pay attention: if the copy protection checkbox is unchecked please check this and click write button.
If the copy protection checkbox is checked leave it alone.
This is important if you leave the copy protect bit unchecked then the new firmware will disable the bootmode, so beware!
5.Serial number and device code section.
Just click the write button in the serial number section. This will rewrite the same serial with the correct checksum.
This was a flaw in my reencrypted serial. A single byte checksum was wrong and the autoelectric discovered this after five years! good. I like this.
6.Close the advanced window, check the TL866A firmware and click reflash again.
强制进入bootmode方法
if the programmer is bricked. you can add a resistor(about 240 ohm) as the follow picture. and install old version software , then reflash firmware. then remove this resistor.
wuxian127
发表于 2019-1-26 23:36:29
fcdsfdsfds fdsafdsfdsf
barve
发表于 2019-2-20 10:12:01
谢谢分享，楼主辛苦了
nod32
发表于 2019-2-22 21:47:10
很棒，刚好用得上，谢谢。
yu1514207
发表于 2019-2-27 13:13:40
这个可可以吗可惜tl866cs/a 都不支持nand
dbtz5
发表于 2019-3-4 14:43:50
太好了，感谢分享
xinhaihaixin
发表于 2019-3-7 11:06:52
不错的资料支持一下
nzj0000
发表于 2019-3-11 20:18:08
很好很好速度古典风格范德萨该罚的
罗鸣
发表于 2019-3-12 10:23:25
好资料！！！！！！