I use a program ft232h AsProgrammer_2.0.3a
The flash is not erased
Current programmer: FT232H
Old SREG: 10001110(0x8E), 01000000(0x40)
New SREG: 10001110(0x8E), 01000000(0x40)
Current programmer: FT232H
16:05:35
Possible protection is enabled. Press "Unprotect" and check datasheet
Erasing memory...
The process can take more than a minute on large flash!
Done
Execution time: 00:00:00
Current programmer: FT232H
16:05:35
Possible protection is enabled. Press "Unprotect" and check datasheet
Programming memory (with verification)...
FT_Read - General IO error...
FT_Write - General IO error...
Verification error on address: 000D4B00
Execution time: 00:00:05
FT_SetBitMode - General IO error...
No problem to connected
Please check if there is any problem with the drive
Try not to use the on-board 3.3V. This is the internal voltage stabilization of the chip, and the current is limited